The Ghost vehicle immobiliser is a unique, next generation device that secures your vehicle without the need for cutting wires or adding after-market key fobs. The device is connected to the vehicles CAN data network and a personalised PIN code is programmed into the Ghost using buttons on the dash and steering wheel.

The Problem...

You have a lot vehicles that need immobilising.

We can quickly and painlessly immobilise the following:

  • Commercial fleets
  • Van fleets
  • Motor homes
  • Cars
  • Agricultural tractors
  • Plant machinery

The Solution


Advantages of next generation vehivle protection

  • Engine start blocking - The Ghost will prevent the starting of the engine unless the unique, user defined PIN code has been entered first.
  • Undetectable using diagnostic - A modern thief can use diagnostics to detect circuit cuts on modern vehicles. The Ghost has no circuit cuts so it cannot be found using these methods.
  • No radio frequency signal - Thieves cannot use sophisticated RF scanning, code grabbing technology to detect what security device your vehicle has when it does not transmit any signals like conventional security systems.
  • Advantages of using the CAN data network CAN - The use of the CAN data bus has several data advantages including low risk during installation, low probability of detection, and allows for placement almost anywhere in the vehicle.
  • Silent operation - Because the unit communicates with the ECU on the data bus to immobilise the vehicle there is no uway a thief could listen for the tell-tale clicking of a traditional immobiliser relay.



Simple PIN code change process

At any time you can easily change the PIN code. Only you will know the unique PIN code for your vehicle.


Emergency PIN code override

If the PIN code is forgotten, the car is sold or a button is broken there is a secure, unique reset code for each device.


Weatherproof tiny device

The Ghost is sealed and so small it can be installed and wrapped into the vehicle harness anywhere in the vehicle making it near impossible for a thief to find.


Stops key cloning and ECU swapping

A thief cannot simply add a new key or replace an ECU to bypass the Ghost and start the vehicle. Only a correct PIN code will allow the engine to start.


Uses the vehicle's original buttons to enter the PIN code

The buttons in modern vehicles send data all around the vehicle which allows us to detect many different keys being pressed without extra wiring.


Service / Valet mode

Service mode allows your vehicle to temporarily start and drive without requiring the PIN code. The Ghost will exit service mode based on speed and time or by simply entering the PIN code.


Tested for each vehicle

Due to the nature of the data bus communication the Ghost has been adapted and tested for every vehicle we list as compatible. If we list your vehicle you can be sure we have thoroughly tested its operation with the Ghost.

The Next Steps


Stop losing vehicles

We'll work with you to immobilise your fleet.


Let us know your requirements

Talk to us, tell us what you need.


We'll take all the hastle away

Instruct us to imobilise your fleet and we'll get is sorted no matter how big your fleet is.

Free Consultation

Talk to a Specialist

Contact us for a free consultation on +44 (0) 1745 770303

18 Lon Caradog
Tan y Gopa Parc
LL22 7DE
United Kingdom

01745 770303

The Bottom Line.

We can expertly immobilise your vehicles and plant machinery quicky and efficiently.